These communication devices link your computer and software to DMX lights, fountain controllers and serial equipment. They work with Masitor software and with other standard lighting software.
uDMX: USB to DMX interface
Plug it into a computer’s USB port and get a DMX512 output for lights, dimmers and fixtures. The simplest way to control DMX lights from Masitor DMX.
Art-Net node
Receives Art-Net over an Ethernet network and converts it to DMX outputs. Use it when lights are far from the control room or when you need many DMX universes over one network cable.
DMX repeater
Boosts and refreshes the DMX signal for long cable runs, so lights at the far end respond reliably.
Universe splitter
Splits one DMX line into several separate outputs. Each output is isolated, so a fault on one line does not stop the others.
USB-485 converter
USB to RS-485 converter for controllers, drives and industrial devices that use RS-485 communication.
USB-RS232 converter
USB to RS-232 serial converter for connecting older serial equipment to a modern computer.
How it all connects
- SoftwareMasitor software creates the show.
- InterfaceuDMX, Art-Net node or USB converter.
- DistributionRepeater or splitter for long lines.
- DevicesLights, controllers and panels run the show.
Frequently asked questions
Should I use uDMX or an Art-Net node?
uDMX is simple and good for one DMX line near the computer. An Art-Net node is better for long distances and many universes, because it uses a network cable.
Do these work with other software?
They use standard DMX512, Art-Net, RS-485 and RS-232, so they can work with other software that supports these standards.
Need help choosing an interface?
Tell us your software, the number of lights and the cable distances.
